USBH869, USB HOST CONTROLLER
Unique USB Host Controller Solution to add one or more USB ports
The USBHC869 USB Host Controller has been specially designed for embedded microprocessor and microcontroller systems. The device adds a USB port, with a low pin count parallel interface and a very small 4x4mm LGA36 footprint. The device also includes a USB host controller that allows Full Speed (12Mbits/sec) USB target devices to be bridged via the USBHC869 to the 16 bit parallel bus. To sustain high throuput rates, the USBHC869 offers separate 16KByte RX FIFOs. The source can be connected. A programmable Phase Locked Loop allows 'crystal free" operation if an external clock is available (of between 2MHz and 32MHz).
USBHC869 - USB HOST CONTROLLER
Performance Features
- Very low standby power
- Fast transfer FIFO design (DMA not needed)
- Supported in Windows 2000, XP and Vista, Windows CE (all versions including CE.NET, PPC, Windows Mobile), Linux and Mac OSX
- Power consumption: Active 20mA/Standby 4uA
- Driver design information available on request
- Fully 'green', lead-free and RoHS compliant
Users
As a high performance alternative to FTDI, Maxim and NXP host controllers the USBHC869 is suitable for the following uses:
- Flash to SD Card data transfer interface for Digital camera to storage interface
- PWM motor control applications e.g. toys
- Telemetry systems
- Ideal for Set Top Box applications due to external data storage, debug port
- Medical systems and Industrial Control applications
- USB Host capability within embedded applications
- USB Flash drive to MCU/PLD/FPGA for data storage and firmware upgrades
Key features
- Tiny footprint 36 LGA package, 0.9mm thick, 4mmx4mm single chip
- Low power 3.3V operation
- Multi I/O standard - 3.3V, 2.8V or 1.8V
- 16-bit low pin count microprocessor interface
- Separate 16KByte TX and RX FIFOs for sustained high data throughputs
- Low power consumption: Active 20mA/Standby 4uA
- Integrated USB transceivers
- Programmable PLL allowing the use of a wide range of crystals or external clock signals from 2MHz to 32MHz (including common frequencies 6MHx, 12MHz, 13MHz and 26MHz)
Applications
The USBHC869 is a USB Controller ideal for embedded applications including mobiles/cellphones, smartphones, UMPC, motherboards, and mobile internet devices (MID)
Full Hardware and Software Developent Kit and application notes for Windows, Linux and Windows CE are available
USBHC869
USBHC869 is a USB Host Controller designed for very low power and small footprint applications such as Smartphones, Tablet PC and other mobile devices.